Learn Electronics

How to Read a Flasher Dial: Bottom, Bait, Fish and Your Jig

010203040123431.0ft
  1. Zero (surface) at the top; depth runs clockwise
  2. Fish: green edge turning red at the core
  3. Your jig: the small mark that moves when you lift
  4. Bottom band: thick and red on hard bottom
How a three-color flasher dial reads. Our own illustrative diagram, not a real unit.

A flasher is a ring of light that shows what's under your hole right now. Zero is at the top, and depth runs clockwise around the dial. Each mark on the ring is something the sonar beam bounced off, and the color shows how strong the return is. On most three-color flashers, red is strongest, orange or yellow is medium, and green is weakest. Check your unit's manual, because palettes vary.

The bottom: the thick, steady band at the depth you're fishing. A hard bottom like rock or sand shows as a solid red band that's often thin. Soft muck shows wider, with more green and yellow mixed in. If the bottom band looks unusually wide, you're probably on a slope or a break, since the beam is hitting several depths at once.

Your jig: the small mark that moves when you lift and drop it. If you can't find it, raise the gain a little until it shows up. A tungsten jig or one with a spoon blade shows brighter than a small plastic.

Fish: a mark that shows up on its own and isn't your jig. It usually starts green or yellow and turns redder as it moves toward the center of the cone. A fish rising off the bottom toward your jig is the moment to stop jigging hard and start teasing.

Bait and weeds: baitfish show as a scattered cloud of thin green marks, often suspended. Weeds look like a fuzzy, flickering band rising up off the bottom. Lower your gain to see whether a mark is a fish or just weed tops.

The two settings to learn first: Gain controls sensitivity; set it just high enough to see your jig clearly, with a little noise left. Too high and the dial fills with clutter, too low and you'll miss fish. Zoom or bottom lock spreads the bottom few feet across the whole dial, making it easy to see a fish hugging the bottom right under your bait.

Common mistakes: running the gain all the way up, fishing a hole over a steep drop and mistaking the slope for fish, and having the transducer hang crooked. If the transducer isn't level, every reading is off, so keep it level and just below the bottom of the ice.

Gear for this guide

Compare store prices: Vexilar FLX-28 ProPack II (Lithium, ProView) · MarCum M1 Flasher System · Humminbird ICE HELIX 7 CHIRP GPS G4 All Season. More: all electronics.

Related guides: Best ice flashers · Vexilar FLX-28 vs Marcum M5 · Flasher lithium batteries.

Heads up: Ice Fish Deals may earn a commission from links on this site at no cost to you. Prices shown come from my price scanner and are accurate only as of the time stamped next to them. Prices change, so confirm at the store before you buy. Disclosure

Frequently asked questions

What does an ice flasher show?

A flasher is a ring of light that shows what's under your hole right now. Zero is at the top, and depth runs clockwise around the dial. Each mark on the ring is something the sonar beam bounced off, and the color shows how strong the return is. On most three-color flashers, red is strongest, orange or yellow is medium, and green is weakest. Check your unit's manual, because palettes vary.

How can I find my jig on a flasher?

Your jig: the small mark that moves when you lift and drop it. If you can't find it, raise the gain a little until it shows up. A tungsten jig or one with a spoon blade shows brighter than a small plastic.